TREATMENT FOR A NEW ENGINE
An Argument Over Running-in Argument is proceeding in the English motoring journals regarding the correct methods of running-in a new ■or rebored engine. Many of the correspondents not only regard the timehonoured 20 m.ph. system as obsolete, but as deleierious. One factor that is obviously not realised by many people is that it is not speed alone that does harm, but speed plus load, or mere overloading .regardless of speed. Far more harm will be done to an engine by sudden throttle opening or by slogging up a steep incline, at 15 m.p.h. with the throttle wide open than by cruising along at 45 m.p.h. with the throttle only a quarter open, especially during the first 1500 miles. Speeds of 30-32 m.p.h., with frequent lifting of the foot from the accelerator pedal, are generally accepted as good practice in driving a new car on fiat roads. The throttle closing has the effect not only of reversing temporarily the bearing loads so as to improve their- oil distribution, but also allows the piston tops to cool, and draw up oil to the top ring. Upper cylinder lubrication, and the use of colloidal graphite in the oil many consider should be stressed by the manufacturers as emphatically as the need for gentle methods in running-in. Many manufacturers content themselves merely with advice against exceeding a certain top-gear maximum. A few give a table of maximum speeds for each gear, but very rarely is anything provided which is so comprehensive as this table:—
For the car for which this table was compiled, the lower speeds correspond to about 1000 r.p.in, and the higher to 2750 r.p.m., or approximately 66 per cent, of the revs, at peak h.p., and on that basis a similar table could be compiled for any car, the gear ratios and wneel sizes of which were known.
Extremely low engine speeds are not advised because of the fact that cylinder lubrication is apt to suffer by reason of insufficient oil mist being thrown off by the crankshaft, as well as the heavy bearing loading which will be introduced by hard pulling at low speeds. Another point mentioned is the desirability of an oil change after the first 200 miles The reason for this is that in this distance, unless the engine has had considerable bench running or road testing at the factory, abrasive particles dislodged from castings may be considerable. With modern systems of oil filtration now usually provided, however, this precaution is less urgent than it was a few years ago.
Not under. Not over First gear . ... — 10 Second gear ... 5 17 Third gear ... 10 23 Top ... 12 30
Permanent link to this item
https://paperspast.natlib.govt.nz/newspapers/DOM19370507.2.175
Bibliographic details
Dominion, Volume 30, Issue 189, 7 May 1937, Page 15
Word Count
445TREATMENT FOR A NEW ENGINE Dominion, Volume 30, Issue 189, 7 May 1937, Page 15
Using This Item
Stuff Ltd is the copyright owner for the Dominion. You can reproduce in-copyright material from this newspaper for non-commercial use under a Creative Commons BY-NC-SA 3.0 New Zealand licence. This newspaper is not available for commercial use without the consent of Stuff Ltd. For advice on reproduction of out-of-copyright material from this newspaper, please refer to the Copyright guide.