Recessing the ends of top bars. First cut: The jig holds the top bars down firmly and is then used to push the bars over the saw. The left hand only steadies the bars. The holding bars of the jig are made of 12in. x 1½in. x ½in. timber and the lower, pushing board of Bin. x 6in. x 13/l6in. timber.
Permanent link to this item
https://paperspast.natlib.govt.nz/periodicals/NZJAG19580215.2.24.20
Bibliographic details
New Zealand Journal of Agriculture, Volume 96, Issue 2, 15 February 1958, Page 145
Word Count
61Recessing the ends of top bars. First cut: The jig holds the top bars down firmly and is then used to push the bars over the saw. The left hand only steadies the bars. The holding bars of the jig are made of 12in. x 1½in. x ½in. timber and the lower, pushing board of Bin. x 6in. x 13/l6in. timber. New Zealand Journal of Agriculture, Volume 96, Issue 2, 15 February 1958, Page 145
Using This Item
Stuff Ltd is the copyright owner for the New Zealand Journal of Agriculture. You can reproduce in-copyright material from this journal for non-commercial use under a Creative Commons BY-NC-SA 4.0 International license. This journal is not available for commercial use without the consent of Stuff Ltd. For advice on reproduction of out-of-copyright material from this journal, please refer to the Copyright guide.