Joining and cutting material to give a continuous length of bias binding. Left—The material numbered and marked jin. from the edges. The mark at I is folded to that at 2, that at 3 to that at 4, and so on down the length of the material. Middle The Seam tacked and stitched so that the material forms a tube. Right-Cutting the tube from one end of the line to the other forms a continuous strip of bias binding. This method is quicker and neater than joining each strip separately.
Permanent link to this item
https://paperspast.natlib.govt.nz/periodicals/NZJAG19500915.2.55.3
Bibliographic details
New Zealand Journal of Agriculture, Volume 81, Issue 3, 15 September 1950, Page 282
Word Count
90Joining and cutting material to give a continuous length of bias binding. Left—The material numbered and marked jin. from the edges. The mark at I is folded to that at 2, that at 3 to that at 4, and so on down the length of the material. Middle The Seam tacked and stitched so that the material forms a tube. Right-Cutting the tube from one end of the line to the other forms a continuous strip of bias binding. This method is quicker and neater than joining each strip separately. New Zealand Journal of Agriculture, Volume 81, Issue 3, 15 September 1950, Page 282
Using This Item
Stuff Ltd is the copyright owner for the New Zealand Journal of Agriculture. You can reproduce in-copyright material from this journal for non-commercial use under a Creative Commons BY-NC-SA 4.0 International license. This journal is not available for commercial use without the consent of Stuff Ltd. For advice on reproduction of out-of-copyright material from this journal, please refer to the Copyright guide.