Bending and padding the wire supports. Above-Leg and tail supports made of single fairly thick wire and the padding of the loops at the ends. Below—A support for all four legs and head made from thin twisted wire. Another section for a tail support could be added if necessary. The ends should be twisted well into the centre piece..
Permanent link to this item
https://paperspast.natlib.govt.nz/periodicals/NZJAG19491115.2.44.10
Bibliographic details
New Zealand Journal of Agriculture, Volume 79, Issue 5, 15 November 1949, Page 506
Word Count
59Bending and padding the wire supports. Above-Leg and tail supports made of single fairly thick wire and the padding of the loops at the ends. Below—A support for all four legs and head made from thin twisted wire. Another section for a tail support could be added if necessary. The ends should be twisted well into the centre piece.. New Zealand Journal of Agriculture, Volume 79, Issue 5, 15 November 1949, Page 506
Using This Item
Stuff Ltd is the copyright owner for the New Zealand Journal of Agriculture. You can reproduce in-copyright material from this journal for non-commercial use under a Creative Commons BY-NC-SA 4.0 International license. This journal is not available for commercial use without the consent of Stuff Ltd. For advice on reproduction of out-of-copyright material from this journal, please refer to the Copyright guide.