INVISIBLE MENDING
An excellent method of invisible mending is to draw out a thread from an inside seam of the garment and darn the torn part with it. Follow as near as possible the weave of the material, and the repair will not be noticed. If there is a hole which will' not look well darned, graft a new piece of material into the garment.
Have the piece five or six inches bigger all round than the actual hole. Run a brightly-coloured tacking thread round the centre to mark the size of the hole. Now draw out the cross threads above and below the lines, and then to the right and left draw out the upright threads. Now tack the piece on to strong paper several inches larger than itself.
Remove any frayed edges from the garment, and tack the paper to it on the wrong side about «• quarter of an inch from the edge. Pull each of the ends of the fringe throu fo .* to the right side and darn into the garment to match the pattern, keeping the new piece flat whilst darning it. Press with a warm iron over a damp cloth, remove the paper and press again.
Permanent link to this item
https://paperspast.natlib.govt.nz/newspapers/EP19400118.2.139.10
Bibliographic details
Evening Post, Volume CXXIX, Issue 15, 18 January 1940, Page 14
Word Count
201INVISIBLE MENDING Evening Post, Volume CXXIX, Issue 15, 18 January 1940, Page 14
Using This Item
Stuff Ltd is the copyright owner for the Evening Post. You can reproduce in-copyright material from this newspaper for non-commercial use under a Creative Commons BY-NC-SA 3.0 New Zealand licence. This newspaper is not available for commercial use without the consent of Stuff Ltd. For advice on reproduction of out-of-copyright material from this newspaper, please refer to the Copyright guide.